Men's Groove 1.0
Resilient as you are.
The Groove 1.0 is ready to stand up to the rigors of everyday training, while also being right at home toeing the start line of any event. The Groove 1.0 utilizes Ultra-light 44Cell HBF-Limestone neoprene™ through the body and legs for maximum buoyancy, while remaining light for the entire duration of your swim. The arms are constructed of 1.5mm DuraStretch neoprene to provide unrestricted flexibility that deboer is known for. When you are putting in the work, day-in and day-out, you need your equipment to be as resilient as you are.
- Super light 44Cell HBF-Limestone neoprene for optimal buoyancy, while remaining light for the entire swim
- 1.5mm DuraStretch neoprene arms
- 44+Cell HBF-Limestone stability panels to help maintain a proper swim position
- GlideSkin™ Surface coating
- Unique neck closure
- Double layer neckline
- 3.0mm AquaGrip™ panels on the arms and the legs
- YKK Zipper
- Made for Cool Temperatures: down to 12° C / 53° F
- Approved for use by Ironman, ITU, and ETU
Made from our HBF-Limestone neoprene (Highly Buoyant, Flexible, and lightweight 44Cell neoprene). We conducted studies to understand how adding buoyancy can affect swim position. Based on these studies, we positioned the panels to create maximum stability, minimize rotation and ensure better balance.
Our unique glide layer coating technology provides exceptionally low water friction and increases hydrodynamics. In addition, it reduces resistance when changing out of your wetsuit, thus, helping to save precious time during your race transition. This coating aids in the reduction of fingernail tears.
The perfectly measured, positioned, finely tuned and extensively tested grooves reduce turbulence and increase the surface area in contact with the water, increasing the efficiency of each stroke and kick and aiding in forward propulsion.
We only use YKK stainless steel zippers which close from bottom to top. This makes opening the wetsuit and getting out much easier and therefore, faster in transition.
Care should be taken when donning the wetsuit to avoid damaging the neoprene skin with fingernails. Always use the pads of your fingers to put on a suit. Do not pinch small folds and pull, make sure to grab large folds of the suit when pulling. Small cuts or tears can be repaired with wetsuit glue.
The exterior surface of your wetsuit is manufactured with a hydrophobic outer skin designed to reduce surface friction (drag.) It is designed to withstand the normal wear and tear during a normal swim session. Care should be taken to avoid contact with sharp rocks or any other sharp objects. Small cuts or tears do not affect wetsuit performance.
Fully unzip the wetsuit before removing one section at a time. Avoid contact with sharp fingernails. Salt and chlorine water can damage the neoprene drying it out and affecting its flexibility. To ensure continued flexibility it is important to soak your wetsuit in lukewarm, fresh water for at least 5 minutes after each use, then thoroughly rinse it with fresh water. To dry, place the wetsuit inside out on a wide hanger in a ventilated place, away from direct sunlight. Maintenance is important, therefore it is recommended to wash your wetsuits with a specialized antibacterial soap every few sessions.
Wetsuit material can develop permanent creases if left folded for an extended period of time. Therefore it is best to store your wetsuit laying flat. Alternatively, hang it on a specially designed wetsuit hanger, thick coat hanger, or as wide and thick a hanger as you can find. Consider the weight of a wet or damp wetsuit and avoid deformation around the shoulders. Some like to roll their wetsuits, but do not fold it under any circumstances.
Zippers are designed to be pulled open and closed in a straight line. Avoid pulling at excessive angles. Ask for assistance to zip and unzip as needed.
Chemicals & Solvent
Avoid contact with oil, gasoline, aerosols or any solvents as they degrade rubber and plastic materials. Do not use any type of alcohol, or lubricant.
Free Shipping Worldwide on all orders above $100 USD.
We offer free standard shipping of all orders worldwide above $100 USD. Price includes all taxes and duties.
For all other purchases, shipment rates are calculated at Checkout.
Can I return my product?
Yes. If you are not 100% satisfied with any deboer product it can be returned within 14 days of delivery provided it is in new condition. For wetsuits new condition means with the tags attached.
Prior to sending your product back to deboer please email us at firstname.lastname@example.org. Returns can be sent to:
deboer wetsuits - Sport Import Europe b.v.
Re: Your name and order number
Einsteinstraat 16 B
3316 GG Dordrecht
deboer wetsuits - Method Sourcing
Re: Your name and order number
103 Carolina Court
Archdale, North Carolina, USA, 27263
How do I submit a warranty claim?
All deboer products are guaranteed against manufacturer defects of material and craftsmanship for 1-year from the date of purchase. In the event you need to submit a warranty claim you can email us at email@example.com. In your email please include:
- Description of the problem
- Photo of the problem
- Your order number or proof of purchase
Our Warehouses and Couriers
We have warehouses in the USA and the The Netherlands. From our US warehouse we ship via FedEx, UPS, or USPS. From our Netherlands warehouse ship via FedEx, Post NL and DPD.